3DPrinter

Thermaltake Riing Fan Rewiring and Pinout

I needed a 120mm fan for my 3D Printer that I was messing around with and found some Thermaltake Riing Plus fans I had lying around, but I needed to control them via a standard fan header rather than using the special 9 pin plug they have. Here’s a quick run down to change the pins around to use it as a standard PC fan, as well as how to wire up the LEDs to work with WLED (on an ESP8266/ESP32), Marlin on an Ender 3 (SKR Mini E3 V1.2) or to a 5V Motherboard RGB header.
Continue reading →

Posted by duck in How-To Guides, Intermediate, 0 comments